After we have key in the close the traverse, the following instruction is go to sub-program-"correction" under Data Computation as shown above.
When we press the sub-program "correction", we need to define which line is the closing line to enable the program to detect the line.
Example how we key in the closing line. You just need to type (2,3) and the box will appeal. You need to select which is the closing line.
Same procedure again but this time is to define the original line for the closing line.
Now you are able to see the above diagram.
The first bearing and distance is close bearing, while the second bearing and distance is original traverse line.
After you success reach this stage, press a "c-correction" buttom on the top and the program will automatic adjusted the whole set of traverse data.
0 comments:
Post a Comment